Wednesday, September 28, 2011

Cisco CCNA Exam Tutorial: Loopback Interfaces

By Hugh Burton


Preparing to pass the CCNA exam and earn this important Cisco certification? Route summarization is just one of the many skills you'll have to master in order to earn your CCNA. Whether it's RIP version 2, OSPF, or EIGRP, the CCNA exam will demand that you can flawlessly configure route summarization.

When you're learning all about the different physical interfaces for your CCNA exam - serial, ethernet, and BRI, among others - there's one logical interface you need to know about, and that is - you guessed it! - the loopback interface.

2501 routers are fantastic for CCNA and CCNP home labs. They come with two serial interfaces, allowing you to connect one interface directly to another router (you'll need a DTE/DCE cable for that, too) while connecting another to a frame relay switch if you like. If you don't have a frame relay switch, you can connect a 2501 directly to two other routers via the serial interfaces.

In contrast, a physical interface being down does not mean the router itself is out of commission. A router's ethernet port can go down, but the other physical interfaces on that router are still operational. Since a loopback interface is logical, there's nothing physical that can go wrong with it.

To come up with the summary route, just work from left to right and draw a line where the four networks no longer have a bit in common. For these four networks, that point comes between the 14th and 15th bits. This leaves us with this string: 01100100 000100xx.

Note that this reserved address range does not apply to loopbacks on Cisco devices, however. If you attempt to assign an address from this range to a Cisco loopback interface, you get this result:




About the Author:



No comments:

Post a Comment